Optimal Energy Take Classic 5.1 Speakers Settings

H

i guys, I wrote this article with a general-to-specific perspective regarding Energy Take Classic 5.1 speakers, and speaker/ sub-woofer settings. Those people who’re interested in knowing how to set up their surround sound speakers; watch the video below – It’s mandatory!

Now that you’ve watched the video, you have tons of ideas on setting up any of your surround sound systems. However, if you’re specifically an Energy Take Classic 5.1 owner, you’re expecting a laser targeted solution.

Read the appended passages to know how you can set up your Energy 5.1 Take Classic speakers, without compromising its sound quality. Do note that this article also explains the sub-woofer placement for Energy Take speakers, which will enable you to get the best surround sound experience ever.

Energy Take Classic 5.1| Optimal Speaker and Sub-Woofer Placement:

Warning: The ideal surround sound quality is dependent on your room dimensions. Add a little bit of your own ideas and tests, alongside this article, to see what works best for you. Also, the ideal distance between each speaker should be 6 feet.

• Side Walls: Both front channel Energy Take Classic 5.1 are supposed to be 4 – 5 feet high and 6 feet away from you. If you’re going to place them on the side walls, there should be a gap of 6 inches between the walls and the speakers.

• Rear Walls: If you’re not planning to install Energy Take speakers on the side walls, the rear wall approach is also good. Try to flank your main listening areas, so much so that you’re ideally sitting in line of these speakers.

• It means that the front and middle channel speakers are supposed to face the entire room, at the height of 6 feet. If you’re not using stands, go for nails.

•    Sub-Woofer: Energy Take Classic sub-woofer settings are best observed when the sub-woofer is placed at one of the following locations:
  • Side of The Wall: There won’t be a lot of bass if the bass hole is facing the wall. But this setting will give you an increased sound fidelity.
  • By The Front Speakers: At the cost of some front channel speaker volume, this setting will allow the Energy Take Classic 5.1 sub-woofer to tout out a perfect mix of bass and volume.
  • Corner of The Room: For maximum bass, set the sub-woofer bass frequency to lowest settings. This will produce high amount of bass/ thump effect and a whole lot of adrenaline rush!

Energy Take Classic 5.1 Test Run!

This is the MOST IMPORTANT part of getting long lasting and permanent results from your energy 5.1 take classic home system. The company calls it the “Break In Phase”. You’re supposed to play a song or anything on these speakers at *NORMAL* Volume for no less than 50 hours.

Just put the same song on repeat or play something boring, every day for a few hours, until 50 hours have worn off. This test run is very important because it allows the speakers to get adjusted to the room surroundings and the type of music that’s usually played by you.

I hope these settings have helped you in straightening the kinks out of your sound system. For more Energy Take Classic 5.1 reviews, settings, best deals and any other information, visit Amazon today at your earliest.